Any Miles From Columbus, OH

Customize your Search Radius & Location

Automobiles585

More Links

Hire It HauledFree / Giveaway ItemsPet GiveawaysWant AdsTradingStores & Dealers

My Links

Saved Searches0 Watch List0 Recently Viewed0

Mechanical Part

577 Results
Tell Fredericks
2024-08-28 13:04:43
Prominent Listing
4 Photos
Aurora 7500 compound turbo kit
Low mile 7500 compound turbo kit in good condition
Halliday, ND
$1,000  OBO
On The Spot Truck Repair
2024-08-28 06:27:37
Prominent Listing
12 Photos
REMAN CUMMINS ISM M11- 450 HP -CM570 ENGINE
REMAN CUMMINS ISM M11 CM570 ENGINE, PROFESSIONALLY REBUILT, DONE RIGHT.
Columbus, ND
$22,995
nathan
2024-09-12 11:51:55
Front differential carrier for a 99-07 Chevy/GMC 1500 pickup with 3:73 gear ratio
purchased from auto salvage for $250 asking $150. My pickup had 4:10 gear ratio so do not need this one
Saint John, ND
$150
XJ
2024-09-12 11:40:16
2003 Subaru Forester Engine 2.5L Single Cam
Runs great, no knocks or rattles. Engine stays at temperature and does not overheat. Mileage unknown. Have video of it running. Single cam 2.5L
Driscoll, ND
$900
cdavis
2024-09-12 11:31:59
5 Photos
Stock 1976 Chevy 882 400 heads and intake. Comes with rockers and rods. Worked r
eally good just upgrading. Has the steam holes. will also throw in the cam shaft that is in good shape.
Saint John, ND
$175  OBO
Joe
2024-09-12 11:13:16
4 Photos
700R4 four speed automatic transmission out of a 1986 corvette. Shifted really wel
l when the driveline was pulled. Have the driveshaft, inspection cover, and converter to go with it as well. $500
Dickinson, ND
$500  OBO
Dylan
2024-09-12 11:05:22
2 Photos
1999 ford f250 gas
V10 Motor is toast. Newer tranny and transfer case. Newer style ford wheels. Interior isnt in good shape. Couple straight panels Sell or trade title in hand
Jamestown, ND
$1,500  OBO
Gavin
2024-09-12 09:20:45
9 Photos
For parts or restoration.
Late 1940’s GMC truck without rear end.
Sawyer, ND
$450
Chad
2024-09-12 09:01:40
LOOKING FOR power steering bracket for 70s 460 motor
Saint John, ND
$123  OBO
W_Hoger
2024-09-12 08:58:50
Used 2012 f550 def tank, pump, and brackets
New Salem, ND
$200  OBO
Harlan
2024-09-12 07:46:05
3 Photos
(Used) Stock Intake Manifold for 1975 454 Cu. In. Engine
(Used) Stock intake manifold for 1975 454 cu.in. engine. Casting numbers 340218, K22 74, conv/3
Bismarck, ND
$50
Lucas Adams
2024-09-12 02:34:13
brand new brake drums, shoes, rotors, and pads for 1995 ford f250 powerstroke 4x4.
$200 or best offer
Minot, ND
$200  OBO
Kent
2024-09-11 19:34:28
K&N Cold Air Intake 2014-18 Chevy GMC 1500 6.2 5.3
Installed for about 2000 miles. Removed before I traded the truck. $300 new price. If it is listed it is for sale.
Bismarck, ND
$200
Tommy
2024-09-11 18:52:02
2 Photos
63 Impala mint, needs motor work
Eureka, SD
$12,000
Blaine
2024-09-11 11:37:59
3 Photos
Edge EZX Fits a 2020-2022 ford 6.7 powerstroke. Took off because I went a differen
t route. Works great and many different features all from an app on your phone. Does not leave a footprint on stock
Wishek, ND
$500  OBO
Bosch
2024-09-11 07:58:50
2009 Laramie dodge 1500
parts pickup Motor, Trans, and transfer case all worked strong before it was partially rolled. Not sure on miles has sat a couple years now would have to put a battery back
Marion, ND
$3,000  OBO
Harlan
2024-09-11 07:38:13
3 Photos
(Used) Carter Quadro Jet
carburetor. Had a new kit installed and worked just fine before being put in storage.
Bismarck, ND
$100
Harlan
2024-09-11 07:38:01
3 Photos
(Used) Rochester Quadro Jet
carburetor. New kit installed, and worked just fine before being put in storage. Does need a vacuum choke pull off.
Bismarck, ND
$90
Driven Motors
2024-09-10 20:49:36
2 Photos
3.5 L engine
Will work for a colorado, canyon or H3 hummer 110k miles, runs good. This is from a 06 H3
Menoken, ND
$2,200
Driven Motors
2024-09-10 20:49:12
2 Photos
6.5l Turbo w/101k miles
Perfect running 6.5l out of a 93 3500, bought it from the original owner and the engine only has 101k miles. I have videos of the motor running, it's almost ready to pull
Bismarck, ND
$1,200
Driven Motors
2024-09-10 20:49:00
Engine and transmission out of 2015 Ford Transit connect. 2.5l
Engine $600 Transmission $2200
Menoken, ND
$600
Cheryl
2024-09-10 20:23:15
1973 454, brackets, pulleys. It was a takeout and turns over. Oil pan and intake.
Also rebuilt TH400. Never used. Dyno’d. Slightly built up. Asking $1800,
Bismarck, ND
$1,800  OBO
Gavin
2024-09-10 19:44:23
3 Photos
Model “T” motor and transmission on a stand.
Ran before it was stored. Present condition unknown. Stored inside.
Sawyer, ND
$600
Rob
2024-09-10 13:08:26
4 Photos
2001 Dodge Ram V-10
132,000 miles Runs like a top Pulled from perfectly good running,driving pickup that was light rollover Intake removed to pull engine Will throw in new cart it sitting on
Williston, ND
$800  OBO
Tom
2024-09-09 23:00:34
Wanted 409 chevy 5408 eldebrock intake small port 2x4 intake. And other 409
parts. 64 impala parts or project car. Tom
Denver, CO
Mike
2024-09-09 20:01:09
3 Photos
Flat head V8 engine with transmission.
Good running flat head V8 engine with transmission. Also an original radiator that is in good shape no leaks. All came out of a 52 F1 pickup
Lincoln, ND
$1,500
10mm
2024-09-09 16:24:16
3 Photos
Brawler 750 carburetor.
Bismarck, ND
$400
Hanyou
2024-09-09 13:07:30
2 Photos
Subaru STI strut brace.
Imported from Japan, had it on my 2001 STI Forester. Not sure what else it will fit, you are welcome to check the placement on your vehicle before purchase. Will be moving
Minot, ND
$150
nddl
2024-09-09 12:16:20
5.4 ford triton engine
engine run good just need cam phasers put in. have a good set of cams Fazer to go with all the coils are there? engine is complete. came out of a 2004. on a pallet
Bismarck, ND
$1,200  OBO
Renee
2024-09-09 09:42:21
3 Photos
Brand new still in the box right and left lower control arms with ball joints for
a 2006 Jeep Grand Cherokee, Selling because I didn't need them Call Joe at 701-202-0516
Mandan, ND
$75  OBO
577 Ads | Page 1 of 20 | Jump to Page: